Replacement Pivot Shaft for Rear Upright, made from 12L14 Carbon Steel, with Precision Ground Finish to a tight-tolerance of +/-.0005″. Yield Strenght : 60,000 psi
Rear Upright lower Sleeve Replacement, is made from Aircraft-Grade 4130 Alloy Steel. These sleeves have been made to the correct length. Therefore they do not need the two fill-in washers the factory used to make-up for the sleeves being to short.
Front Camber Lock Set – This set locks the upper ball joint in place after all alignment adjustment have been made. Made from Aircraft 6061 T-6 Aluminum.
Reviews
There are no reviews yet.