Description
Sway Bar polyurethane Bushing 1″ to be used on IPS008 and IPS1175 products. These Bushing have channels molded inside for grease to minimize the squeaks that polyurethane is known for when they are dry.
IPS008I-XX Polyurethane Insert Grease-able
Sway Bar polyurethane Bushing 1″ to be used on IPS008 and IPS1175 products. These Bushing have channels molded inside for grease to minimize the squeaks that polyurethane is known for when they are dry.
$21.00
In StockAdditional information
| Weight | 1 lbs |
|---|---|
| Dimensions | 6 × 6 × 4 in |
| BAR SIZE | 7/8 Inch, 1 Inch |
You may also like…
-
Pantera PartsIPS008-X Sway Bar Cap – w/ Engraved Detomaso Logo
Sway Bar Caps are CNC machined from 6061-T6 Aircraft Quality aluminum. These caps can be used on all 8 cap locations, 4 on the rear sway bar, and 4 on the front sway bar. For the best results these should be used on the four inner locations and use IPS092 Ball Caps on the outer four mounting points. The Logo is machined into the cap after the part is anodized to give a great contrast. They are available in Black and Clear anodize.
(Sold as Pair)
(0 reviews)$69.00 Select options This product has multiple variants. The options may be chosen on the product page
Related products
-
Pantera PartsIPS002 Front Camber Lock Kit
Front Camber Lock Set – This set locks the upper ball joint in place after all alignment adjustment have been made. Made from Aircraft 6061 T-6 Aluminum.
(0 reviews) -
Pantera PartsIPS051 Water Restrictor Plate Modified / Thermostat Blockoff Plate – 351C Engine
Thermostat Block off Plate / Water Restrictor Plate Modified – 351C Engine
This block off plate is use to allow removal of the stock thermostat to help cooling.
(0 reviews) -
Pantera PartsIPS096 Rear Lower Pivot Shaft
Rear Lower Pivot Shaft
Replacement Pivot Shaft for Rear Upright, made from 12L14 Carbon Steel, with Precision Ground Finish to a tight-tolerance of +/-.0005″. Yield Strenght : 60,000 psi
(0 reviews) -
Pantera PartsIPS127-XX Adjustable Rear Camber Tower Bar
Adjustable Rear Camber Tower Bar
This bar mounts between the rear engine bay towers to support upper A-Arm pivot points. Made from Aircraft 6061 T-6 Aluminum with 303 SS adjustment screw and locking nuts, Unit is Black Powder Coated then engraved .
(1 review)$299.00 Select options This product has multiple variants. The options may be chosen on the product page
Reviews
There are no reviews yet.