Billet High Flow K&P Engineering Oil Filters

The filter element is made from medical grade, type 304 stainless steel micronic filter cloth to provide unmatched protection against oil contamination and resultant engine damage. A one inch square of this material flows an incredible 1.9 gallons of oil per minute at only 1 PSI pump pressure. The adhesive used in the filter assembly process is good to 600 degrees Fahrenheit, far above normal engine operating temperatures. A super strength nickel-plated neodymium rare earth magnet is installed in the top of the element for magnetic pre-filtering of the oil. The sophisticated bypass is engineered for proper differential pressures and consistent operation, delivering a greater percentage of filtered oil while being very easy to clean. The twist lock design assures positive filter element placement and allows for easy disassembly, inspection and cleaning. The quad-ring gasket doubles the seal between the filter and the engine. Finally, the filter housing is carved out of a solid chunk of 6061T6 billet aluminum, which not only looks trick but aids in dissipating heat.

 

IPS160-15 (92-06) ................................... $ 159.00 - Billet Machined Alum Finish

IPS160-15A (92-06) ................................... $ 164.00 - Anodized Black Finish

IPS160-15C (92-06) ................................... $ 184.00 - Chrome Finish

 

IPS160-17 (08-15) ................................... $ 159.00 - Billet Machined Alum Finish

IPS160-17A (08-15) ................................... $ 164.00 - Anodized Black Finish

IPS160-17C (08-15) ................................... $ 184.00 - Chrome Finish